Ver. 1A
Section 2
Connecting the Switch
The 5 Gigabit Ethernet ports of 10/100/1000MbpsAuto-Negotiation ports of the
switch support automatic MDI/MDIX crossover detection, which allows for true
“plug-and- play” capability. With the Auto-MDI function, you can simply plug in an
Ethernet cable into the switch without worrying about if the other end of the cable
is connected to a network adapter or to another switch or hub.
Quick Installation Guide
5-Port 1000BASE-T Gigabit Ethernet Switch
Model #AGIGA5SW-B
Connect the AGIGA5SW-B to an end note which includes PCs outfitted with a 10,
100, or 1000 Mbps RJ-45 Ethernet Network Interface Card (NIC) and most routers.
An end node can be connected to the Switch via a twisted-pair Category 3, 4, 5, or
5e UTP/STP cable. The end node can be connected to any of the ports of the
Switch.
Package Contents:
•
•
•
5-Port Gigabit Switch
Power Adapter
Quick Installation Guide
LED Indicators
1) The 5-port switch has built-in LED indicators:
Power LED
• Solid Green – Power On
Speed LED (Top)
Section 1
• Solid Green – 1000 Mbps
• Solid Amber – 100 Mbps
• Off – 10 Mbps
Introduction
Link/Act LED (Bottom)
• Solid Green – Link
• Blinking Green – Activity
This user’s guide tells you how to install your 5-Port 1000BASE-T Gigabit
Ethernet Switch, how to connect it to your Gigabit Ethernet network.
2) Cable Diagnostic Operation indications (during the switch booting up):
The 5-Port 1000BASE-T Gigabit Ethernet Switch was designed for easy installa-
tion and high performance in an environment where traffic on the network and the
number of users increase continuously.
Open, Short, or Improper Termination
• Speed LED:Amber
• Link/Act LED: Off
Cable connection good
• Speed LED: Green
Before you begin, please verify that you have all the parts listed in the Package
Contents.
• Link/Act LED: Off
|